The owner of a commercial facility or the owner of an apartment building does not need to put a steeply-sloped roof on that particular structure. Yet the same structure does not some type of roof. For that reason, a facility owner or a building owner should take the time to become acquainted with low-slope membranes.
Simple roofing systems with a membrane
EPDM: Black, synthetic rubber used in the making of this structure (membrane). It can be held onto the roof’s deck in different ways. It might be held by ballast, normally stones or concrete. Alternatively, it could be attached to the deck by mechanical means.
TPO: a white thermoplastic material. This provides the building owner with the chance to choose between 3 different ways for holding the TPC-membrane in place. Two of those are the same as the ones used with EPCM membranes, ballast and a mechanical device. The third selection calls for utilization of a fully adhered system.
DVV: another white, thermoplastic material; more compliant than the TPO membranes.
More complex roofing systems with a membrane
BUR: Built up roof; contains either bituminous or modified polymer. Can be a multiply system. Must be installed by a roofing crew. That requirement showcases the complexity of this particular system. The crew doing the installation applies one of 3 different kinds of coverings. It could be a bitumen and gravel coating. Alternately, the covered membrane could cap sheets with a mineral surface. Roofing company in San Jose knows that the final choice calls for utilization of a liquid-applied roof coating.
As indicated, each of the listed system creates a roofing structure. Each of those structures has a slight slope, so that rain cannot form puddles on the rooftop. In other words, the membrane’s presence makes up for the flat nature of the rooftop structure that is found on most commercial buildings.
Unlike a home, the commercial building does not have a wooden deck, one into which a covering might get nailed. Instead a commercial building has a hard surface underneath as its rooftop structure. No covering can be mailed into that same surface.
Membranes function as a substitute for the nailed-down shingles. Yet roof-installers have arrived at different means for holding-down a given membrane, in the absence of acceptable nails. Hence, building owners get to choose the means that works best on the roof that covers their personal investment.
Ideally, their selection demonstrates a consideration of their needs. Those that require a pliant material normally buy one of the membranes that contains DVV. Those that do not feel concerned about a membrane’s level of compliance purchase one that contains synthetic rubber, TPO, or the content of a built-up roof. At the same time, the completed rooftop needs a slope.
SAN JOSE